2020 Audi A4 Flat Tire Emergency Procedure

Sparky Express

2020 Audi A4 Flat Tire Emergency Procedure, How To

If yous have a apartment tire on your 2020 Audi A4:

  • Park the vehicle equally far equally possible from moving traffic, on a hard level surface.
  • Set the parking brake
  • Switch the chance lights on
  • If whatsoever there are any passengers in your vehicle, have them exit and move to a safe place.

Advertisements

2020 Audi A4 Flat Tire Equipment

In your vehicle, y'all should accept a vehicle tool kit, tire mobility kit and vehicle jack, located in the baggage compartment under the cargo flooring encompass (trunk).

2020 Audi A4 vehicle tool kit is located under the cargo floor in the trunk.

  • To open the front compartment, pull the cargo flooring cover by the strap (1).
  • To open up the rear compartment, lift the cargo flooring by the plastic handle (2).
  • Hook the plastic handle into the luggage compartment seal (2) or,
  • To remove the cargo floor completely, pull it toward the rear at the plastic handle (2).
  • If your vehicle has a spare tire, turn the handle counter-clockwise and remove the spare tire.
  • Unhook the cargo flooring before closing the lead on your body.

Depending on vehicle equipment, the vehicle tool kit, tire mobility kit, and compressor may be located nether another cover that is secured with a hand-wheel.

If your vehicle has the jack in a storage handbag, the jack bag is secured with necktie-straps in the luggage compartment and must be re-secured the aforementioned manner after usage.

Using The 2020 Audi A4 Tire Mobility Kit

This type of  flat tire repair (inflation with slime) is meant for temporary use only. Change the damaged tire equally soon as possible. If the tire is punctured past a precipitous object such every bit a nail, practise non remove the object from the tire. The tire mobility kit tin exist used at temperatures as low as (-four°F) or (-xx°C).

The mobility kit must not be used if:

  • the flat tire has cuts or punctures larger than 0.xvi in (4mm)
  • the rim is damaged
  • you accept driven with very low or no force per unit area in the affected tire.

How to repair your 2020 Audi A4 tire

2020 Audi A4 tire mobility kit components.

2020 Audi A4 tire mobility kit connection

Setting upwardly the tire mobility kit

  • Open the compressor cover (2)
  • Remove the connector (4) and pressure hose with force per unit area approximate from the housing (5)
  • Connect the compressor's pressure hose (5) to the flange (6) on the tire sealant bottle (1)
  • Insert the sealant bottle with the flange at the bottom into the opening (3) on the compressor comprehend
  • Remove the valve cap from the damaged tire
  • Install the filler hose (9) on the valve (7)
  • Connect the plug (4) to an outlet in the vehicle
  • Switch the ignition on
  • Movement the switch (8) on the compressor to the on position (I)
  • Inflate the tire to 29 psi (200 kPA) and 36 psi (250 kPA) and read the force per unit area on the gauge.
  • If the force per unit area is non reached, removed the filler hose. Bulldoze slowly approximately 33 ft (10 1000) forward or in contrary then that the sealant can exist evenly distributed on the inside of the tire
  • Inflate the tire once more
  • Affix the sticker that says "max 50 mph (max 80 km/h) that is provided with the tire mobility kit, on your windshield, inside your field of vision
  •  Stop the vehicle afterwards driving 10 minutes and check the tire force per unit area
  • If the tire force per unit area is lower than xix psi (130 kPA), then the tire is too severely damaged. Do not proceed driving.

Changing a tire on your 2020 Audi A4

  • Set the parking brake
  • Select the "P" position
  • When towing a trailer, disconnect the trailer from your vehicle
  • Lay out the vehicle tool kit
  • Switch off the ignition

Removing the caps

2020 Audi wheel bolts with caps

  • Slide the plastic clip from the vehicle tool kit onto the cap until it engages.
  • Remove the cap with the plastic clip.

Loosening the wheel bolts

Loosening the wheel bolts on 2020 Audi A4

  • Slide the wheel wrench from the vehicle tool kit all the style onto the wheel bolt.
  • Turn the wheel commodities approximately i turn to the left. To reach the required torque, concord the end of the cycle wrench. If the bicycle commodities doesn't loosen, press advisedly on the bike wrench with your foot. Concur onto the vehicle securely while doing this and make sure you foot is stable.

Raising the vehicle

2020 Audi A4 sill panel markings

2020 Audi A4 Sill positioning of the vehicle jack

  • Identify the vehicle jack from the tool kit on a house surface. Use flat, stable support if needed. On a slippery surface such as tile, you lot should always use a not-sideslip pad such as a rubber mat.
  • Notice the marking on the sill that is closest to the apartment tire that needs to be changed. Behind the marking, there is a lifting signal on the side sill for the vehicle jack.
  • Turn the hand-wheel to raise the vehicle jack (ane) under the lifting point on the side sill until the subclass on the jack completely covers the notch on the vehicle.
  • Marshal the vehicle jack then the bracket (1) covers the notch and the base (2) is flat on the footing. The base (2) must be direct under the mounting signal.
  • Mountain the crank on the bicycle jack past inserting the creepo into the opening in the hand-wheel. Plow the crank to the left or right to secure information technology.
  • Continue raising the vehicle jack with the creepo until the wheel is slightly off the ground.

Removing and installing a cycle

2020 Audi A4 Wheel internal hex socket to turn the wheel bolts.

2020 Audi A4 Wheel alignment pin in the top hole.

Removing a cycle

  • Remove the meridian wheel commodities completely using the hex socket in the screwdriver handle from your 2020 Audi A4 tool kit and identify it on a clean surface.
  • Install the alignment pin from your tool kit in the empty bicycle bolt hole by hand
  • Remove the residual of the wheel bolts
  • Remove the bicycle, while the alignment pin remains in the elevation hole.

Installing a wheel (please beware of directional tires!)

  • Slide the wheel on over the alignment pin
  • Install the bicycle bolts and tighten them gently using the hex socket.
  • Remove the alignment pin and tighten the remaining wheel bolt
  • Tighten the wheel bolts in a diagonal pattern using the cycle wrench
  • The bicycle bolts must be clean and loosen and tighten easily. Check contact surfaces for the wheel and hub. Contaminants on these surfaces must be removed earlier installing the bike.
  • Brand sure that your wheel bolts are torqued with a torque wrench to the required wheel bolt torque for your 2020 Audi A4 according to owner'southward transmission

Collapsible spare tire

The collapsible spare tire is intended for curt-term use only. Have the damaged tire checked and replaced if necessary by an authorized Audi dealer or authorized Audi Service Facility, as soon as possible.

There are some restrictions on the use of the collapsible spare tire. The collapsible spare tire has been designed specifically for your type of vehicle. Do not supervene upon it with a collapsible tire from some other type of vehicle.

The collapsible tire is located in the luggage compartment of your 2020 Audi A4 (in the trunk), under the cargo floor cover.

Removing your collapsible tire:

  • Lift the cargo floor using the handle
  • Turn the hand-wheel counter-clockwise and remove it
  • Remove the collapsible tire

You must inflate the collapsible tire before using it.

Inflating your collapsible tire:

  • Remove the valve cap from the collapsible spare tire
  • Tighten the compressor hose on the collapsible tire
  • Connect the compressor hose to a vehicle socket and switch it on
  • Let the compressor run until the specified value on the tire force per unit area is reached
  • Screw the valve cap dorsum on the valve head

Returning your collapsible spare tire to storage:

  • To release air, plough the valve insert
  • Turn the valve insert back one time the air has been released
  • Wait several hours earlier placing the collapsible tire in the spare wheel well. Only then will it fold downwardly completely so that you can shop information technology securely.
  • Screw the valve cap back on the valve head
  • Secure the collapsible spare tire with the manus-wheel
  • Fold the cargo floor cover back into its place.

Too complicated? Got a apartment tire on your 2020 Audi A4? Phone call Sparky Limited at (647)-819-0490 and nosotros will either install your spare wheel, or even set your flat tire right where you are! Nosotros provide roadside assistance on-demand, no membership needed. Our roadside assistance services are available for your 2020 Audi A4 in Pickering, Ajax, Whitby, Oshawa, Markham and Toronto, Ontario.